The use of liquid filter cartridge

instructions on the use of the liquid filter core

. Thoroughly clean the filter first
. Filter paper box, unpack filter, pay attention to the above tags and plastic bags are in good condition
. Open the plastic bag, check whether the seal is installed
.
with liquid wetting o-rings. To plastic packaging for protection, hold nearly socket end filter, filter vertical pressure into filter positioning hole, the card into the type filter must rotate card tight
. 'll take out the plastic bags, cover plate, with nut and tighten
. Open the filter at the top of the exhaust valve
. Open the inlet valve slightly, causes the liquid into the filter when liquid overflow from the exhaust valve, then close vent valve
. Slowly open the downstream outlet valve to fully open the
directly. Adjust the inlet valve slowly, until fully open
. The filter with L/h per inch flow flush minutes
. Should not be big traffic impact filter, avoid compression
the opposite direction. If the filter pressure difference is greater than the. Mpa or flow decreases obviously, suggests that filter most of the hole has been blocked
. Such as folding filter temporarily not to use, should not filter drier, and the filter should be stored in the filter, filter into the water containing antimicrobial

guangzhou filter source water filter co. , LTD. Product:
liquid purification filter water treatment filter

DN basket type pall big water flow cartridge filter
the CTO sintering carbon filter
inch wire wound filter