Guide - the filters filter cleaning methods 【 3 m filter.

Water purification machine when using should not put it in direct sunlight place, especially the use of the water purifier water purification machines, water purifier filter containing activated carbon, medical stone, mineralization ball, pearl quality raw materials such as, prone to communities under the sunlight, service center through repeated experiments show that the water filter in the filter in the sun, 20 minutes to communities. At the same time, water purification machines are regularly cleaned. Use bottled water purification machine should be cleaned once every quarter cold ( With cold water use) ; With a water purifier cold water machine should be cleaned once a month. And the thermal insulation in the water purification machine ( Hot water use) Should be cleaned to professional department.

the filters filter cleaning methods:

1 separate filter from top to bottom section, on with a clean tap water rinse filter ( Ceramic) At the same time, you can use without clean brush a tooth new toothbrush to brush filter surface;

2 will be on the filter within about half a pot of water, shook the filter several times up and down, down to the rest of the water, can be a few times, reciprocating smooth filter pore.

3 will be under the filter filled with tap water, up and down with the palm flat mouth, make the next filter jitter, and make the water clean filter material. Repeated several times until it from the filter out of the water clear.

cleaning method, one is to use special germicides, 2 it is to ask professional cleaning cartridge replacement or will be out of the water after cleaning fluid.

activated carbon filter cleaning methods:

1 outer winding line, pipe and wire mesh with high pressure water washing, brush, and soak in bleach solution of chlorinity M an hour, and then rinse clean with water.

2 simple cleaning method of granular activated carbon is poured out activated carbon granule and to reload after water washing several times.

3 granular activated carbon correct cleaning method, bubble with dilute hydrochloric acid after four hours, clear water is rinsed clean, then three hours at 200 ℃ oven dry, remove with clean water to rinse again, to return to the active.