Oil and gas separation filter, the main performance factors and summary of maintenance - 【 3 m filter.

Principle of oil and gas separation filter technology is particles of dust in the air, oil and gas and liquid material removal. Oil and gas filter of oil mist in the gas separation, intercept and aggregation, formed in the filter at the bottom of the oil droplets in the returns to the compressor system.

a, installation and maintenance

when to differential pressure, oil and gas separator pp filter must be replaced and install or replace filter must pay attention to ensure that all the conditions there are no errors. During installation and replacement of filter, it is important to ensure the oil separation tank and oil content on one side of the filter dry clean, easy to operate the surface of the filter layer separation, reduce oil carrying quantity increase, efficiency, and blockage of the filter impurities in dry on one side of the back line, oil gas zone phenomenon.

the destruction of the filter design pressure difference is 4 bar, so the air compressor should be gradually after booster valve until the need of load gas, open the calculation of the absolute forbidden suddenly vent, the filter fine separation layer bursting and flattening filter, and a lot with oil.

beyond the use of oil and gas separation pp filter design velocity range, oil carrying quantity will increase.

2, some measures to prolong the working life

the correct management of fuel is the key to decide the working life of the oil and gas separation filter, working life mainly restricted to just fine separation layer deposition of solid particles, the result is that the increase of the pressure difference. Usually replace the air filter and oil filter and keep on time according to certain time interval in oil, can restrict the dirt into the oil circulation loop, this can be done to reduce dirt into the oil and gas separator, can directly extend the working life of the oil and gas separator pall pall filter.

as well as the selection of oil is also very important, should only be used by the identification of aging resistance of the fuel and water sensitivity, the lack of oxidation resistance does not apply to oil after running a fairly short period due to the residue of shaped like jelly will block filter, high work test will also accelerate the aging of oil.

3, pall pall filter the main performance index of the

water treatment filter performance index is the key to the efficiency of water treatment, size, service life, high temperature resistant capacity, oil removal purifying effect, differential pressure strength and ease to operate, and other aspects.