Water purification device filter parts replacement process in detail 【 3 m filter.

Filter element as the core technology of water purification device, play an important role in the process of the whole water treatment. But after a period of time the running of the water purifier, filter will be affected by different degree of pollution. In order to ensure the water purification device can run normally, stable discharging water, prior cartridge must be replaced periodically. Replacement cycle according to the inlet water quality, as the case may be, usually in about three months, but if found filter color have change, need to change in a timely manner.

water purifier filter replacement process description:

1, close water three-way ball valve ( Note: when the ball valve and in vertical state tee for closed) ;

2, will lead to two hose pulled at the ends of the transparent bottle, and write down the hose connection direction;

3, will lead a transparent bottle of black side down, put the water inside control dry;

4, white at the front filter outlet with adjustable spanner quick joint screw down;

5, the front transparent bottle placed horizontally in front of the ground, the special spanner from bottom of transparent bottles in the bottle. The screwdriver with his left hand, right hand hold special wrench handle. The right hand to the inside of the body force unscrew the filter bottles.

if the lid is too tight and rotating motionless, please put black lid side two minutes of immersion in boiling water, using the principle of heat bilges cold shrink, and easier to spin, note only soak black lid;

6, remove the old filter filter accessories, and wash bottles of internal and filter cap. Loaded with the specifications of the new filter, the black lid, and to the body of the lateral rotation special wrench handle according to the fifth step, further tightening the filter bottle;

7, the white with adjustable spanner quick joint screw well. Insert the white hose profiteer inlet, and the other a hose inserted into the outlet. Hose to be inserted to the bottom, and then gently pull out the hose, card ring will hose clamp tightly;

8, bottle upright front filter and adjust position, open the inlet tee ball valve, and then turn on the tap, water for a few minutes later, the joint inspection equipment, can use normally after to ensure no leakage.

water purification device can effectively remove harmful impurities in water, ensure that water quality meet the national drinking water standard, the water treatment filter with low cost, easy to change, and water purification device in the whole operation process does not produce secondary pollution to water quality, are widely used in drinking water industry.