Water purifiers pre - 3 m folded filter replacement method 【 3 m filter.

In order to ensure the normal operation of water purifiers, providing fresh water, regular replacement front filter, cycles are usually about 3 months, Note: the water quality and water use is affect change frequency, found that the filter color darker please change as soon as possible) 。

one, 3 m Microwynd Y16 previa filter need special wrench tool

1, 1, adjustable spanner screwdriver 1

note: change the core process there will be water overflow, please prepare birdbath, towels and other appliances.

2, 10 inch pp filter replacement process:

1, close water three-way ball valve ( Note: when the ball valve and in vertical state tee for closed) 。

2, will lead to two hose pulled at the ends of the transparent bottle, and write down the hose connection direction.

pull hose method: with the tip of his finger on white fast connection card ring, pull out the hose at the same time.

note: tube drawing must to hold the card ring first, and then pull the hose

3, will lead a transparent bottle of black side down, the water control dry inside.

4, the front filter with adjustable spanner outlet ( Have & other; ” Mark) The white screw down quick connectors. From one word screwdriver outlet ( Have & other; ” Mark) Into the black lid, as the left hand grip.

5, the front transparent bottle placed horizontally in front of the ground, the special spanner from bottom of transparent bottles in the bottle. The screwdriver with his left hand, right hand hold special wrench handle. The right hand to the inside of the body force unscrew the filter bottles.

tips: if the lid is too tight and rotation does not move, please put black lid side two minutes of immersion in boiling water, using the principle of heat bilges cold shrink, and easier to spin, pay attention to soak only black lid.

6, remove the old filter, and clean the bottle inside and filter cap. Loaded with the specifications of the new filter ( Pay attention to remove plastic wrapping paper) on the surface of the new filter , the black screw on the lid ( To avoid & other; O” Type rubber band shift) , and according to the step 5 ways to the body of the lateral rotation special wrench handle, further tightening the filter bottle.

7, the white with adjustable spanner quick joint screw well. Insert the white hose profiteer inlet ( Have & other; IN” Mark) And the other a hose inserted into the outlet ( Have & other; ” Mark) 。 Hose to be inserted to the bottom, and then gently pull out the hose, hose clamping make card ring.

8, bottle upright front filter and adjust position, open the inlet tee ball valve, and then turn on the tap, water for a few minutes later, each joint inspection machine, to ensure no leakage can be normal use after water purification equipment. When

element changes, must pay attention to the above points, to avoid damage in the machine and accessories and affect the subsequent water quality and the service life.